Makita ADP10 Betriebsanleitung Seite 4

6. Do not charge the battery cartridge in pres-
ence of flammable liquids or gases.
7. Do not expose this adapter and battery char-
ger to rain, snow, or wet condition.
8. Never carry charger by cord or yank it to dis-
connect from receptacle.
Do not carry charger by this adapter installed
9.
to the charger or by the battery cartridge
installed to this adapter. Otherwise it may cause
falling and result personal injury.
10. After charging or before attempting any main-
tenance or cleaning, unplug the charger from
the power source. Pull by plug rather than cord
whenever disconnecting charger.
11. Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise sub-
jected to damage or stress.
12. Do not operate charger with damaged cord
or plug. If the cord or plug is damaged, ask
Makita authorized service center to replace it
in order to avoid a hazard.
13. Do not disassemble this adapter. Reassembly
may result in a risk of electric shock or fire.
14. Do not operate this adapter if it has received a
sharp blow, been dropped, or otherwise dam-
aged in any way; take it to Makita authorized
service center. Incorrect use may result in a
risk of electric shock or fire.
15. Do not charge battery cartridge when room
temperature is BELOW 10°C (50°F) or ABOVE
40°C (104°F). At the cold temperature, charging
may not start.
16. Do not attempt to use a step-up transformer,
an engine generator or DC power receptacle.
17. Do not allow anything to cover or clog the
charger vents.
18. Do not plug or unplug the cord and insert
or remove the battery and adapter with wet
hands.
19. Never use gasoline, benzine, thinner, alcohol
or the like to clean this adapter. Discoloration,
deformation or cracks may result.
Charging
CAUTION:
Follow the steps instructed in this
manual. If you insert the battery with the adapter to
the charger mounted on the wall, the battery or the
adapter may come off and fall off.
1. Plug the battery charger into the proper AC volt-
age source.
2. Insert the adapter into charger until it stops adjust-
ing to the guide of charger.
3. Insert the battery cartridge to the adapter.
4. When the battery cartridge is inserted fully,
charging will begin.
5. After charging, remove the battery cartridge from
the adapter while sliding the button on the battery
cartridge.
6. Remove the adapter from the charger while slid-
ing the button on the adapter. Then unplug the
charger.
NOTICE:
This adapter is for charging Makita
battery cartridge. Never use it for other purposes
or for other manufacturer's batteries.
NOTE: The terminal cover of the charger opens as
you insert the adapter and closes as you pull out the
adapter.
The terminal cover of the adapter also opens as you
insert the battery cartridge and closes as you pull out
the battery cartridge.
NOTE: The pattern of the indicator lamps is varies
depending on the charger.
Refer the instruction manual of the charger to check
the status of charging.
4 ENGLISH