Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
This instruction manual contains important
information and must be read carefully by
competent persons prior to any handling,
transport, inspection or installation of this
product. Every care has been taken in the
preparation
of
information; however, it is the responsibility
of the installer to ensure the system
complies
with
international regulations, especially safety.
The manufacturer, Soler & Palau Sistemas
de
Ventilación
responsibility for breakages, accidents or
any inconvenience caused by failure to
comply with the instructions contained in
this manual.
The fan units referred to in this manual
have been manufactured in accordance
with
rigorous
International standard ISO 9001. Once the
product has been installed, this manual to
be retained by the end user.
Transport and manipulation.
The packaging used for this fan unit has
been
designed
transporting conditions. The fan unit must
always be transported in its original
packaging as not doing so could deform or
damage the product. The fan unit must
always be transported in its original
packaging. Do not accept delivery if the fan
is not in its original packaging or shows
clear signs of having been damaged.
The product should be stored in a dry place
in its original packaging, protected from
dust and dirt until it is installed in its final
location.
Do not place heavy weights on the packed
product and avoid impact damage.
Any lifting equipment must be safe and of
suitable capacity for weight and size.
Special attention may be required to
ensure fan assembly does not distort or tilt
as weight distribution may vary. Never lift a
product by pulling it by the wires or terminal
casing. Likewise, no pressure should be
the
instructions
relevant
national
S.L.U.
accepts
quality
control
to
support
applied on the propeller, turbine or safety
grid while manipulating the product.
Storage
Storage must be in a safe, flat, controlled
and
environment
especially
moisture,
and
Recommend that duct connections (inflow
and
outflow)
dust/debris entering the equipment.
no
These data may also apply to an installed
fan, which is not put into operation for
extended period.
Important information for the safety
of installers and users.
Installation must be carried out by
and
qualified
accordance
precautions
required by law, regulations and
standards in the country applicable.
All fan units are designed and
normal
manufactured in accordance with
EC
accessories are available from S&P
if
required
installation.
Working ambient temperature for
fan unit equipment should not be
exceeded typically this will be within
-20°C to +40°C, unless stated
otherwise.
This fan unit must not be used in
explosive
atmospheres.
If the fan unit is to extract air from
premises where a boiler or other
combustion appliance is installed,
make sure that the room has
to
prevent
from
water,
corrosion,
are
closed
persons
with
applicable
Directive.
Safety
due
or
damage,
sand,
dust,
temperature.
to
avoid
acting
in
all
safety
and
as
guard
to
specific
corrosive
Werbung
