Safety During Installation - S&P JETLINE 100 ECOWATT Bedienungsanleitung

by children aged from 8 years
and above and persons with
EN
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge if
they have been given super-
vision or instruction concern-
ing use of the appliance in a
safe way and understand the
hazards involved. Children
shall not play with the ap-
pliance. Cleaning and user
maintenance shall not be
made by children without su-
pervision.
• Means for disconnection must
be incorporated in the fi xed wi-
ring according with the wiring
rules. An external disconnec-
ting device, which will function
as the "designated" disconnect
device must be provided, and:
1) It shall
"Line", while disconnection
of the "Neutral" is optional;
2) Its OFF-position shall be
clearly marked;
3) Not to position the equip-
ment so that it is diffi cult to
operate it; and
4) The protection current de-
vice must be at least 10A,
250V, curve Type C.
10
disconnect the

SAFETY DURING INSTALLATION

Fan unit equipment should be electrically isolated
and locked out before any work started.
The Installer, User is responsible for ensuring that the
fan unit is installed, operated and serviced by qual-
ifi ed personnel, acting in accordance with all safety
precautions applicable and as required by law, regula-
tions and standards in the country applicable.
Safety protective clothing, equipment, hearing protec-
tion, and tools may be required.
Before any installation work is started, ensure that fan
unit equipment is correct for application. Location for
installation is solid, level, fl at and suitable for mount-
ing fan unit assembly.
Fan unit should be located in position, and assembled
with any accessory equipment supplied, on relevant
mounting, anti-vibration mountings, safety protection
guards, on a solid level base to avoid any distortion
and misalignment and with correct air direction as
shown on nameplate. Fan unit should then be levelled
on any anti-vibration mountings. Flexible connectors
must be taught to ensure no disruption to air fl ow, es-
pecially on inlet to fan unit.
Make sure there are no loose elements near the fan
unit. When the fan unit is mounted in a duct, check
that it is clean of any elements and exclusively used
for ventilation system.
The electrical installation must include a double pole
switch with a contact clearance of at least 3 mm,
correctly sized and in accordance with the electrical
standards of the country of installation.
For electrical connections follow the wiring diagram
"A" indicated in this manual.
The fan unit classifi ed as Residential Ventilation Unit
with control factor 0,65 have to comply with the re-
quirements of the European Directive 2009/125 and
must be installed following the local demand control
defi nition given in the regulation nº1253/2014 (See
fi g.B as example).
START UP
• Check fan unit equipment name plate data is ap-
propriate to the location electrical supply, especially
Voltage, Frequency, Phase, Amps, speed are correct.
• Check earth connections, electrical terminations
and terminal box lid, with any seals, if fi tted, are
correct.
• In compliance with Machine Directive, if the fan unit
is accessible to operators and is a health and safety
risk, adequate protection must be fi tted, informa-
tion for safety equipment, including guards, can be
found in S&P accessories catalogue.