Olivetti ECR 5500 Kurzanleitung Seite 5

6. SET A FIXED VAT RATE
1. Open the printer compartment cover and slide the control switch to the PRG position.
2. Type the [number] that represents the VAT (1 for VAT1, 2 for VAT2, 3 for VAT3 and 4 for VAT4).
3. Press the [Card] key.
4. Type the VAT rate. Up to five digits can be used, and you MUST enter three digits after the desired decimal place.
For example, to enter a 5.5% VAT rate, type [5500]; to enter a 16% VAT rate, type [16000].
5. Press the [Amt Tend/TOTAL] key.
NOTE: If you make an error, press the [C] key and start again from step 2.
6. Program another feature or exit program mode by sliding the control switch to the OFF position.
Example: Set a VAT1 rate of 5.5%, VAT2 rate of 7%, VAT3 rate of 16% and a VAT4 rate of 20%.
Type/Press:
[1] + [Card] + [5500] + [Amt Tend/TOTAL]
[2] + [Card] + [7000] + [Amt Tend/TOTAL]
[3] + [Card] + [16000] + [Amt Tend/TOTAL]
[4] + [Card] + [20000] + [Amt Tend/TOTAL]
7. CHANGE THE DECIMAL POINT POSITION
The decimal point setting is preset to the x.xx format. This format can be changed, as needed, to one of the other
settings below.
1. Open the printer compartment cover and slide the control switch to the PRG position.
2. Type [1] followed by the status number [0, 1, 2 or 3] to select the desired format as indicated in the following
table:
Status Number
0
1
2
3
3. Press the [RA/FC] key to set the new format.
4. Program another feature or exit the program mode by sliding the control switch to the OFF position.
Example: Program the cash register so that two digits are left after the decimal point.
Type/Press:
[1] + [2] + [RA/FC]
Format
x
x.x
x.xx
x.xxx
3