Setting The Dip-Switch; Factory Setting - Pfannenberg DTS Serie Betriebsanleitung

ENG
4.6.3

Setting the DIP-switch

Fig. 14: Setting the DIP-switch
1 Fan fastening screws
2 Upper screw (card cage)
3 Card cage
The DIP-switch on the controller facilitates the setting of the target and limit values for temperatures.
The default factory setting of the values in the delivery condition is as follows:
Parameters
Setpoint of the switch cabinet temperature
Maximum value of the switch cabinet temperature
Tab. 4: Factory setting of the DIP-switches on the controller
Operating Manual | Attachment and Installation Cooling Units | Standard Controller (SC) – 230 V | 086100001d
ON
OFF 1 2 3 4
4 Lower screw (card cage)
5 Controller
6 DIP-switch

Factory setting

35 °C
50 °C
G00011
34/60