Error Displays - Clarion DXZ588RUSB Bedienungsanleitung

All manuals and user guides at all-guides.com
01_DXZ588RUSB_EN.book 41 ページ ２００７年１１月２７日 火曜日 午後６時５分

9. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
Error Display
ERROR 2 A CD is caught inside the CD
deck and is not ejected.
ERROR 3 A CD cannot be played due
to scratches, etc.
ERROR 6 A CD is loaded upside-down
inside the CD deck and does
not play.
ERROR 2 A CD inside the CD changer
is not loaded.
ERROR 3 A CD inside the CD changer
cannot be played due to
scratches, etc.
ERROR 6 A CD inside the CD changer
cannot be played because it
is loaded upside-down.
ERROR 2 The files are not proper MP3/
WMA/AAC format.
ERROR 3 The MP3/WMA/AAC files are
improperly encoded.
(USB/MTPmode)
ERROR 3 The iPod contains no audio
files.
(iPod mode)
ERROR 5 The connected devices are
not recognized.
BUS-PWR Overcurrent detection.
HUB The connected devices are
not recognized.
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
Cause
This is a failure of CD deck's mechanism and consult
your store of purchase.
Replace with a non-scratched, non-warped-disc.
Eject the disc then reload it properly.
This is a failure of CD changer's mechanism and
consult your store of purchase.
Replace with a non-scratched, non-warped disc.
Eject the disc then reload it properly.
Use only properly encoded MP3/WMA/AAC files.
Use only properly encoded MP3/WMA/AAC files.
Insert an iPod containing audio files.
Disconnect the device and reconnect.
Disconnect the devices and reconnect. If the devices
are still not recognized, try replacing with a different
devices.
Disconnect the devices and reconnect. If the devices
are still not recognized, try replacing with a different
devices.
Measure
41
DXZ588RUSB