Clarion DXZ588RUSB Bedienungsanleitung Seite 15

All manuals and user guides at all-guides.com
01_DXZ588RUSB_EN.book 15 ページ ２００７年１１月２７日 火曜日 午後６時５分
Basic Operations
Q curve
The Q curve becomes sharper when the
numerical value is increased, and smoother
when the numerical value is decreased.
Flat frequency characteristics can be made by
selecting a Q curve opposite to that of the curve
to be compensated.
Q curve : 1
Q curve : 20
Adjusting the bass
The bass gain, bass FREQ (center frequency)
and bass Q can be adjusted as follows.
The adjustment can only be performed when the
DZE is set to "DZE OFF".
2-1. Select "BASS".
2-2. Press the [ ] button.
2-3. Push the [SEEK PANEL] leftward or
rightward and select from:
"B GAIN" "B FREQ" "B Q"
3-1. Press the [UP] or [DN] button to adjust the
gain, the FREQ (center frequency) and the
Q.
B GAIN: –7 to +7 (The factory default
setting is "0")
B FREQ: 50Hz/80Hz/120Hz (The factory
default setting is "50")
B Q: 1/1.25/1.5/2 (The factory default
setting is "1")
3-2. Press the [ ] button to return to the
previous mode.
Adjusting the treble
The treble gain and treble FREQ (center
frequency) can be adjusted as follows.
The adjustment can only be performed when the
DZE is set to "DZE OFF".
2-1. Select "TREBLE".
2-2. Press the [ ] button.
2-3. Push the [SEEK PANEL] leftward or
rightward and select from:
"T GAIN" "T FREQ"
3-1. Press the [UP] or [DN] button to adjust the
gain and FREQ (center frequency).
T GAIN: –6 to +6 (The factory default
setting is "0")
T FREQ: 8KHz/12KHz (The factory default
setting is "12K")
3-2. Press the [ ] button to return to the
previous mode.
Adjusting the sound restorer
The sound restorer enriches the playback of all
types of music files that have undergone any
level of data compression.
∗ The factory default setting is "OFF".
2-1. Select "S RESTOR".
3-1. Press the [UP] or [DN] button to adjust.
Each time you press the [UP] or [DN]
button, the sound restorer changes in the
following order:
"OFF" "1" "2" "3"
Set this adjustment in accordance with the
music source used.
OFF: For music sources compressed at
high bit rate
1: For music sources compressed for high
quality at low bit rate
2: For music sources compressed for
standard quality at low bit rate
3: For music sources compressed for low
quality at low bit rate
Setting high pass filter
2-1. Select "HPF".
3-1. Press the [UP] or [DN] button to select the
setting. Each time you press the [UP] or
[DN] button, the setting changes in the
following order:
"THROUGH" "50Hz" "80Hz"
"120Hz"
∗ The factory default setting is "THROUGH"
(through).
Setting low pass filter
2-1. Select "S-W LPF".
3-1. Press the [UP] or [DN] button to select the
setting.
Each time you press the [UP] or [DN]
button, the setting changes in the following
order:
"THROUGH" "50Hz" "80Hz"
"120Hz"
∗ The factory default setting is "THROUGH"
(through).
DXZ588RUSB
15