Faults - Habegger HIT-06 Originalbetriebsanleitung

TGT, 26.06.2017
6

Faults

Faults
Shear off the overload protection
Rope jams in device
Rope not being transported,
Rope just goes back and forth
Functional fault
Casing bent or broken
Anchor bolts or casing bent
Load hook bent open
Icied
* Replace shearing pin
If necessary, remove some of the load until the shearing bolt is outside the
casing, Image 9. Unlock and pull off the lever pipe by turning it.
Hit broken pieces of the pin out of the bore using a punch and hammer.
Remove the reserve pin from the clamping jaw opening lever (HIT 6/10) or
handle (HIT 16/32).
Line up the bores on the lever pieces and hammer in the new shearing pin.
Danger! Only use original Habegger brass shearing pins.
Stronger shearing pins can result in the pulley device overloading and breaking.
©Copyright by Habegger Maschinenfabrik AG
Betriebsanleitung
Technik
possible cause
Rope force too high
Rope damaged or kinked, jammed at the
clamping jaws (bird-caging)
Incorrect rope used
Rope discharge jammed, rope run
against anchor bolt
Rope worn out or
incorrect rope diameter used
Device dirty,
Foreign object inside
Device was unable to adjust freely in the
direction of the tension.
Anchoring bolts not properly inserted or
not properly secured
Incorrect load
Cold
Measure
Reduce the load or use rope pulleys
Replace shearing pin *
Replace rope or
send the device to Habegger or an au-
thorized repair shop for repair
Use original Habegger rope. Ø according
to type plate
Clear the rope discharge
Replace rope or
use original Habegger rope
Take device apart (casing), clean, lubri-
cate
Send the device to Habegger or an au-
thorized workshop for repair.
Send the device to Habegger or an au-
thorized workshop for repair.
Replace load hook
Defrost with hot air blower
Version 03 / 26.06.2017
Seite 45 von 52
9