Safety; Residual Risks - Relyon plasma piezobrush PZ2-i Betriebsanleitung

Safety

1 Safety
1.1

Residual risks

This device has been manufactured in accordance with the current state of the art.
However, it is impossible to eliminate residual risks.
Always adhere to the following safety instructions:
Caution – electrical voltage!
Only use the power supply unit provided.
Danger due to line voltage. If the power supply unit is visibly damaged:
- Do not start up the machine.
- Replace the damaged parts or have them repaired by a qualified person.
Attention – emissions!
Dangerous amounts of the reaction gas ozone (O
operation.
- An amount of ozone in excess of 0.2 mg/m³ may be produced.
- Note that national health and safety measures must be observed when
operating the device.
- Only use the device in well vented areas or in conjunction with a suitable
exhaust system.
Attention – damage to device!
The plasma generator may be damaged if it is operated without gas flow.
This would interrupt the supply of cooling medium required in operation.
Never touch the piezo crystal on the front side of the machine with sharp-edged objects.
This component may be damaged by improper handling.
Protect the plasma generator from falls or other hard impacts which may damage the
electronics or piezo crystal.
6
(ES) Equipements Scientifiques SA - Département Composants & Modules - 127 rue de Buzenval BP 26 - 92380 Garches
Tél. 01 47 95 99 84 - Fax. 01 47 01 16 22 - e-mail: comp@es-france.com - Site Web: www.es-france.com
) may be produced during machine
3