Herunterladen Inhalt Inhalt Diese Seite drucken

Prolonged Disuse; Instructions For Cleaning; Reminders For Cleaning - ALI PROXE 70 Serie Anweisungen Für Installation, Gebrauch Und Wartung

Nudelkochgeräte
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 29
At the end of each day, clean the well thoroughly in
order to prevent the formation of corrosive deposits.
FILLING AND EMPTYING THE WELL
Filling
Close the well drain tap (knob on bottom of front panel).
Open the water supply tap (knob on control panel) and
fi ll the well to the reference mark.
Emptying
Open the well drain tap (knob on bottom of front panel).
ATTENTION! Opening the drain tap can result in pilot
light extinction.
BURNER IGNITION AND EXTINCTION
The gas tap control knob has the following positions:
Off
Pilot ignition
Minimum fl ame
Maximum fl ame
Pilot ignition
Press and turn the knob to position "
Press the knob down fully and light the pilot using the
piezoelectric igniter.
Hold the knob down for about 20 seconds before
releasing it. If the pilot fl ame goes out, repeat the
operation.

REMINDERS FOR CLEANING

The manufacturer will not be liable for any damage or
injury resulting from failure to observe the following
rules.
Disconnect the appliance electrical power supply, if
present, before proceeding with any operation.
Clean the satin fi nish stainless steel exterior surfaces,
the cooking wells and the surface of the hotplates every
day.
At least twice a year, have an authorized technician
clean the internal parts of the appliance.
Do not use direct or high pressure water jets or steam
cleaners to clean the appliance.
Do not use corrosive products to clean the fl oor or shelf
beneath the appliance.
Instructions for use
".

Instructions for cleaning

Main burner ignition
Turn the knob from position "
Next, depending on cooking requirements, turn the knob to
any position between "
Switching off
To switch the main burner off , turn the knob to position "
".
To switch off the pilot fl ame, press and turn the knob to
position "
".
AT THE END OF SERVICE
Switch the burners off .
Empty the well completely.

14. PROLONGED DISUSE

Before any prolonged disuse of the appliance, proceed as
follows:
Clean the appliance thoroughly.
Rub stainless steel surfaces with a cloth soaked in
Vaseline oil to create a protective fi lm.
Leave lids open.
Close the valves and turn off the electrical power supply
at the main switch.
Following prolonged disuse, proceed as follows:
Inspect the appliance thoroughly before using it again.
Allow electric appliances to operate at the lowest
temperature for at least 60 minutes.
SATIN FINISH STAINLESS STEEL SURFACES
Clean the surfaces with a cloth or sponge using water and
proprietary non-abrasive detergents. Follow the grain of
the satin fi nish. Rinse repeatedly and dry thoroughly.
Do not use pan scourers or other iron items.
Do not use chemical products containing chlorine.
Do not use sharp objects which might scratch and
damage the surfaces.
COOKING TANKS
Clean the wells by bringing the water to the boil, with
the addition of grease remover detergent if necessary.
Remove any limescale deposits with a proprietary
limescale remover.
" to "
".
" and "
".
27

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis