Installation Instructions; Electrical Connection - Whirlpool ACM 854 Gebrauchsanweisung

Warnings
• Before performing any repair or other
work, disconnect the appliance from the
electrical power supply.
• The appliance must be correctly installed
by a qualified technician in accordance
with the applicable safety standards.
• It is essential that this appliance is
earthed.
• The manufacturer cannot accept any
liability for personal injury or damage to
property resulting from a failure to
comply with the above-mentioned
standards.
• Remove the cardboard protections from
inside the oven.
• Fit the accessories.
• The sides of furniture or appliances located
next to the cooker must be capable of
withstanding temperatures which can reach
80°C.
• This appliance complies to CLASS X
(protection against fire hazard).

Electrical connection

Before connecting the appliance, it is necessary
to ensure that:
1. The nominal voltage of the electrical power
supply to the dwelling is the same as that of
the appliance, as stated on the rating plate.
2. The power supply line to which the appliance
is to be connected is of a sufficient power,
relative to the maximum power consumed by
the appliance, as stated on the rating plate.
3. The electrical power installation of the
dwelling is correctly earthed.
Chart 1
Power supply voltage
Conductors no. per dimensions
Electrical connection
E = Green - yellow
N = Blue
}
L 1
L 2 = Brown or Red
L 3
34

INSTALLATION INSTRUCTIONS

• An omni-polar circuit-breaker must be
installed, with a between-contact spacing
of 3 mm or more.
Replacing the supply cable
To connect the cooker supply cable, proceed as
follows (see Fig. 1 ):
• Remove screw (A) and open the cover.
• Remove about 60 mm of the external
sheathing from the power supply cable. The
earthing wire, which is coloured yellow and
green, must be 30 mm longer than the other
power cable wires.
• Pass the power supply cable into conduit (B)
of the terminal board, then into cable clamp
(C) (the terminal board is placed on the rear
external part of the appliance), tightening the
screw (S).
Connect it to the terminal strip in accordance
with the electrical diagram shown below.
• Ensure that the "GREEN and YELLOW" wire
is connected to the earth terminal (marked by
the symbol ).
• Fix the cable into the cable clamp, using
screw (S).
Note: Following installation, the electrical parts
must not be accessible without the use of an
appropriate tool. The power supply cable must
be of the type H05RR-F, in accordance with the
table below (Chart 1).
The supply cable must not come into contact
with any component the temperature of which
exceeds the ambient temperature by 50°C.
Fig. 1