Care And Cleaning Instructions - Whirlpool ACM 854 Gebrauchsanweisung

Before any cleaning operation
disconnect the appliance from the
mains.
Hotplates
Clean the hotplates when they are warm (not
hot!).
Use a cloth moistened with water and salt.
Dry and clean with a cloth moistened with
cooking oil.
Glass ceramic cooking zones
Clean the cooking zones when they are cool,
after each use. This will prevent the build-up of
dirt and make cleaning easier.
• Use a clean cloth, absorbent kitchen wipes
and washing up liquid or a specific glass
ceramic hob cleaner.
• Remove baked-on dirt with a suitable
scraper, which can be bought by specialized
shops, and specific cleaning products.
• Food spills should be cleaned off before they
bake onto the glass ceramic surface.
• Do not use abrasive products, bleach, oven
cleaner spray or pan scourers.
• The hob should be treated periodically with a
proprietary brand of protective wax for glass
ceramic hobs.
• Do not spill sugar or similar substances on
the cooktop to avoid damaging the surface.
If necessary, clean it immediately.
Enamelled surfaces
• Clean with a damp sponge using soap and
water.
Grease can be removed easily using hot
water or a specific product for cleaning
enamelled surfaces. Do not use scouring
powder. Do not clean hot surfaces. Do not
leave any acid or alkaline substances (lemon
juice, vinegar, salt, etc.) on the enamel.
• Clean the parts in stainless steel with specific
cleansers for stainless steel surfaces.

CARE AND CLEANING INSTRUCTIONS

Oven
Clean the walls of the oven with hot water and
soap.
Dissolve any food residues with a specific oven
cleaner, then rinse and dry thoroughly.
When the oven is cold, clean the outside glass
parts. Do not scouring powder or abrasive pads.
Oven light
If it is necessary to replace the oven light bulb,
switch off the main power supply.
Bulb: 15 W / 230 V, type E14, heat-resistant to
300°C.
Removing the oven door
Open the oven door completely. Grasp hook (A)
and insert it into the catch above it.
Close the door about half way and gently pull in
the direction of the arrow.
To reassemble, perform the same operations in
reverse order.
39