Cleaning, Care, Maintenance; Cleaning, Care & Maintenance; How Often Should The Various Parts Be Cleaned; Cleaning The Pressure Cooker - GSW EASY CLICK Gebrauchsanweisung

DKT EasyClick DE-GB-FR Seite 24 Mittwoch, 27. Juni 2012 5:36 17

7. Cleaning, care, maintenance

Your new pressure cooker is easy to maintain. In
order to enjoy your pressure cooker for a long
time, please ensure you always observe the
following cleaning instructions.
7.1 How often should the various parts be
cleaned?
Activity Frequency Chapter
Clean base 7 After each
use
Clean When dirty
pressure
regulator 8
Clean lid 2 After each
use
Clean sealing After each
ring 6 use
Replace When
sealing ring needed,
1 x year

7.2 Cleaning the pressure cooker

Caution! Never use harsh or abrasive cleaning
products, as this may damage the pressure
cooker.
Please note: If possible you should clean the
pressure cooker directly after use so that any
leftovers do not dry and stick to the base.
Base (7):
Clean the base 7 after each use:
1. Wash the base with hot water and washing-
up liquid.
2. Rinse with clean water.
3. Dry the base with a tea towel to avoid any
water marks.
Please note: The base is dishwasher friendly.
24
Pressure regulator (8)
1. Unscrew the fastening bolt for the pressure
regulator 8 by turning it it in an anti-
clockwise direction. Use the key 12 supplied
for this purpose.
"7.2 Cleaning the
pressure cooker"
"7.2 Cleaning the
pressure cooker"
"7.2 Cleaning the
2. Lift the pressure regulator 8 up and out.
pressure cooker"
"7.2 Cleaning the
3. Rinse the pressure regulator with clear, hot
pressure cooker"
water.
Available in
Note: You can also use a small amount of
specialist shops
mild detergent and a very soft brush if
necessary.
4. Clean the lid (see section below).
5. Re-insert the pressure regulator into the lid.
6. Tighten the fastening bolt for the pressure
regulator 8 by screwing it in a clockwise
direction. Use the key 12 supplied for this
purpose.
Note: If steam is escaping from the safety
opening 2 after the pressure regulator 8 has
been fitted, check:
• whether the fastening bolt for the pressure
regulator 8 is properly tightened
–the fastening bolt should be tightened firmly
by hand using the key 12.