Operation - Elica Super Plat Montage- Und Gebrauchsanweisung

Operation

WiFi button
WiFi configuration: if the WiFi function is
not configured, press for about 2 seconds
to enter WiFi configuration mode and
follow the instructions on the App to
complete the procedure.
During the configuration procedure, the
button will light up indicating the
connectivity status (see WiFi status table)
To interrupt the WiFi configuration
procedure, press for about 2 seconds
when the button is lit up and is flashing
fast.
Once the WiFi function has been
configured, if you want to change it, press
for about 6 seconds to reset the WiFi
parameters (the button will turn off) and
repeat the configuration procedure.
• WiFi activation/deactivation: after the
configuration, it is possible to
deactivate/activate the WiFi function.
Press for about 2 seconds to
deactivate/activate the WiFi function.
Deactivating the function does not cause
the loss of the WiFi parameters
WiFi status table
WiFi button
Light off
White light on
steady
Orange light
flashing fast
Orange light
flashing slowly
White light on with
short flashing
orange light
Device connection status
WiFi not configured or off
WiFi connected
Attempt to connect to the
WiFi router
Attempt to connect to the
Elica cloud
Remote command being
received (e.g. engine
ignition or light turned on)
ON/OFF light button
Press to turn the cooktop light on or off.
In selected models only:
Intensity regulation: With the light on,
press and hold to adjust the light intensity.
"BOOST" speed selection key
1st push : to enable the intensive suction
speed "BOOST 1", timed for 30 minutes
this prolonged timing has been designed
to guarantee a suitable cooking time for
preparations that release high amounts of
smoke during cooking
Note : after 30 minutes, the hood will
return to the suction speed previously set
2nd push
activate the intensive suction speed
"BOOST 2", timed for 7 minutes
Note: after 7 minutes, the hood will return
to the previously set suction speed
3rd push ("BOOST 2" activated): to exit
the function and return to the speed
previously set.
Note: the speed key previously set
remains lit during BOOST operation.
Speed selection key 3
Push to activate the high speed (suction
power)
Speed selection key 2
Push to activate the
(suction power)
Speed selection key 1
Push to enable the low speed (suction
power)
Power button
Push to switch on the hood and enable
speed selection;
if pushed while the motor is running, the
latter will stop
Note: if no function is activated within 10
seconds, the hood turns off.
18
("BOOST 1" activated): to
average speed