Installation Of Indoor Unit - Tekno Point CONSOLLE Serie Benutzer- Und Installationsanleitung

Installation of indoor unit

Step 1: Choosing installation location
Recommend the installation location to the client and then confirm it with the client.
Step 2: Installing a hook
1. Attach an installation cardboard horizontally to a wall.
2. Make a mark on the wall according to the hole location
indicated on the installation cardboard.
3. On the top mounting holes, secure two hooks in
locations 1 and 2.
4. After identifying the installation location, thread two
screws into holes on the left and right sides.
Step 3: Open piping hole
1. Open a piping hole with the diameter of Φ55 on the selected outlet pipe position. In order
to drain smoothly, slant the piping hole on the wall slightly downward to the outdoor
side with the gradient of 5-10°.
Note:
● Pay attention to dust prevention and take relevant safety
measures when opening the hole.
● The plastic expansion particles are not provided and
should be bought locally.
2.To prevent damage to the pipes and cables passing through a wall hole and also to avoid
damage caused by rats in a hollow wall, install a wall pipe. Seal the wall hole on the inner
and outer sides with sealant.
3.The highest point of the wall hole cannot exceed the bottom of a wall-mounted AC to
prevent water leakage.
Step 4: Identifying a pipe outlet
Pipes can be led out from the right, rear right, left or left rear side. When pipes (cables) are
routed on the right or left side, cut off the lower parts remaining on the bottom of the case
and the side panel of the AC as required.
● Cut off lower part 1 only when a power cable is led out.
● Cut off lower parts 1 and 2 when both the drain pipe and power cable are led out.
● Cut off lower parts 1, 2, and 3 when the connection pipe, drain pipe and power cable are
led out.
48
Hooking
Indoor Outdoor
5~10°
Φ55