Operation Guide - Tekno Point CONSOLLE Serie Benutzer- Und Installationsanleitung

Operation guide

Installation batteries
1. Press the back side of remote controller marked with "
push out the cover of battery box along the arrow direction.
2. Installation two 7# (AAA 1.5V) dry batteries, and make sure the position of "+" polar and "-"
polar are correct.
3. Reinstall the cover of battery box.
Operation guide
1. After connecting the power, press "
conditioner.
2. Press "MODE" button to select your required mode: Auto, Cool, Dry, Fan, Heat.
3. Press " + " or " - " button to set your required temperature. (Temperature can't be adjusted
under auto mode).
4. Press "FAN" button to set your required fan speed: auto, fan1, fan2 , fan3 , fan4, fan5,
stepless speed.
5. Press " " or "
NOTE:
● During operation, point the remote control signal sender at the receiving window on indoor unit.
● The distance between signal sender and receiving window should be no more than 8m, and there
should be no obstacles between them.
● Signal may be interfered easily in the room where there is fluorescent lamp or wireless telephone;
remote controller should be close to indoor unit during operation.
● Replace new batteries of the same model when replacement is required.
● When you don't use remote controller for a long time, please take out the batteries.
● If the display on remote controller is fuzzy or there's no display, please replace batteries.
" button to select fan blowing angle.
", as shown in the fig, and then
" button on remote controller to turn on the air
33