Tekno Point CONSOLLE Serie Benutzer- Und Installationsanleitung Seite 44

Buttons on remote controller
button
Press this button to turn on or turn off the SMART function, for more details, please see next
page for Smart APP User Guide.
Function introduction for combination buttons
Child lock function
Press "+" and "-" simultaneously to turn on or turn off child lock function. When child lock
function is on, "
controller, the "
Temperature display switchover function
In the off mode, press "-" and "MODE" buttons simultaneously to switch temperature display
between °C and °F.
Timing defrost
In the heating mode, press "SLEEP" and "TURBO" buttons together for 3s would start or
cancel the Timing defrost.
Low temperature heating function setting
● In heating mode, pressing "Mode" and "+" button at the same time will enter/exit the low
temperature heating function.
● "LA" would be showed on the remote controller after entered into the low temperature
heating funtion.
● When switching from one mode to another mode, low temperature heating function was
canceled. Turn off and then turn on air conditioner that will remain the low temperature
heating function. After powered on, the low temperature heating mode was default to off
status.
● In the low temperature heating mode, "SLEEP" and "Low temperature heating" function
cannot start at the same time.When low temperature heating mode has already started,
meanwhile you press the "SLEEP" button, the air conditioner will exit low temperature
heating mode and enter the sleep mode. Vice versa.
Note:
1. In the low temperature heating mode, the fan speed was default to Auto and non-ajusatable.
2. In the low temperature heating mode, "TURBO" and "QUIET" can't be set. If enter the low
temperature heating mode, the turbo and quiet function that started before will be canceled.
As well as when exit the low temperature heating mode, it will not resume .
3. When exit from the low temperature heating mode, the speed and temperature will turn
into the original condition before it started.
4. You can set up other function.
" icon is displayed on remote controller. If you operate the remote
" icon will blink three times without sending signal to the unit.
40