4.2 Maintenance plan
The plan specifies the minimum requirements for maintenance routines to ensure that the equipment is always wor-
king properly.
Components
Task
Breathing
Visual, tightness and functional test
connection
Functional test / check by the user
Cleaning and disinfection
Maintenance to be performed by e-breathe Service
Breathing air hose Visual, tightness and functional test
Functional test / check by the user
Cleaning and disinfection
Maintenance to be performed by e-breathe Service
Flutter Valve
Change of the flutter valve
Visor seal
To be replaced depending on the condition,
at the latest every six months
Face Sealing
Replace depending on condition
Filter
Check the expiry date
Visual inspection
Check filter capacity
Blower
See instruction manual of the blower filter unit!
(Change filter, check / charge battery, cleaning and disinfection and
annual service dates)
Compressed Air-
See operating instructions of the CA control valve!
(replace seals, check couplings, check warning point, cleaning and
Control Valve
disinfection and annual service dates)
In order to guarantee the functionality of the equipment, it must be serviced annually by an authorized service part-
ner or the manufacturer. Authorized service partners can be found under:
www.e-breathe.de
• Check the condition of the visor and its seal edge and replace if necessary.
• Check the condition of the air hose and replace if necessary.
• The maintenance recommendations for blower motors can be found in the user manuals for blower motors.
• Only original replacement parts may be used.
Important: Only use original e-breathe Safety products. Do not make any changes to the equipment. Use of non-
original parts or modifications to the equipment may reduce the protective function, jeopardize product approvals
and permanently damage the equipment. Non-compliance will void the warranty.
e-breathe • info@e-breathe.de • www.e-breathe.de
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
Rev. 5.0
x
x
x
x
x
x
x
x
24