Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL GE-LS 18 Li Originalbetriebsanleitung

cutting blade will open automatically.
6.3 Finishing your work
Switch off the equipment as described in section
6.1.2. Fit the blade guard hood back over the cut-
ting blade and clip it in place.
6.4 Belt clip
You can use the belt clip (Fig. 1 / Item 7) to hang
up the equipment, e.g. from your belt. Both your
hands are then free and the equipment is always
within easy reach.
7. Cleaning, maintenance and
ordering of spare parts
Hazard!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
7.2.1 Changing the (movable) cutting blade
(Fig. 8)
When the cutting blade becomes blunt or worn
you can replace it yourself (see section 7.3) or
have it replaced by your service workshop. Take
care not to injure yourself with the cutting blade.
Warning! For safety reasons, self-locking nuts
are allowed to be used only once without excep-
tion.
Proceed as follows:
1. Switch off the equipment with the ON-OFF
main switch (OFF position) and remove the
battery.
Anl_GE_LS_18_Li_SPK9.indb 20 Anl_GE_LS_18_Li_SPK9.indb 20
GB
2. Remove the self-locking nut M8 (wrench size
13) (Item E), the corrugated washer (Item F)
and the washer (Item H).
3. Remove the bolt (Item K).
4. Remove the movable cutting blade (Item 1).
5. Insert the new movable cutting blade.
6. Reinsert the bolt.
7. Place the washer and the corrugated washer
on the bolt.
8. Screw an unused self-locking nut M8 (wrench
size 13) onto the bolt.
•
There are no other parts inside the equipment
which require maintenance.
7.3 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.Einhell-Service.com

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 20 -
15.09.2020 09:40:07 15.09.2020 09:40:07