Teufel WJT 5 Gebrauchsanweisung Seite 24

ES
FR
EN WJT 5 Lock System
D D
DE
Application/
Adjustment
We recommend executing
the following steps of the
application process in the
order suggested below.
Assembly
Flatten the center of the
surface on the distal end of the
residual limb for the dummy, at a
right angle to the axis of the limb.
Clamp the model into a vacu-
um tube. Reduce the limb end
to a surface with a 47 mm
diameter. (Fig. 1)
1
The angle of the flatte-
ned surface will later define
EN-8
the direction of the pin.
User Manual
Attach the lamination dummy
(included in the lamination
dummy kit) with the included
nails. (Fig. 2)
2
Pull a thin stockinette over
the model (we recommend
using Feather Stretch
material, REF PA.0013x00)
and tie it off along the notch
on the dummy. (Fig. 3)
3
Unscrew the locking mecha-
nism (left-hand thread) from
the lock body. Use the SW16
hexagonal socket key