the accident prevention regulations laid down for electrical
equipment by the appropriate trade associations must be observed.
In schools, educational facilities, hobby and DIY workshops,
operation of the product must be responsibly supervised by trained
personnel.
During operation, the charger, the power cord and the charging
cable must be checked at least once a week for externally visible
damage.
If you are not certain about the right way to connect or operate
the device, or if any other questions that are not covered in the
operating instructions arise, please contact our technical inquiry
department (see P. 47) or another qualified technician.
Do not place the charger on top of valuable furniture; this also
applies to storage when not in use. It is possible for chemical
reactions with the rubber feet to cause discolouration, and pressure
marks can also develop.
There are no components inside the device requiring adjustment of
servicing by the user. Use a suitable underlay.
Position the charger, the battery and the cables in such a way that
nobody can stumble over them.
In spite of the comprehensive, versatile protective circuits, incorrect
function or problems when charging a battery cannot be ruled out.
Only operate the product in a moderate climate, never in a tropical
climate. Observe the suitable environmental conditions described in
the „Specifications" chapter (see page 47).
Choose a location for the device that is strong, large and smooth
enough. Otherwise, there would be a risk of injury from the weight
37