Connection Diagram; Overview, Bus-2/Bus-1 Connection; Detector Group Inputs - Honeywell 010128 Montage, Anschluss, Anleitung

18 Mounting and Connection Instructions 2 Detector group module BUS-2/BUS-1, f.m.
9.

Connection diagram

9.1

Overview, BUS-2/BUS-1 connection

Data
BUS-2/
0 V
BUS-1
U_b
+U_b
0 V
Shield
9.2

Detector group inputs

The terminal allocation of the 2 detector groups is identical
DG
R
EOL
int.
0 V
Note: The value of the end-of-line resistor R
Connection example:
1
Magnetic contact
2
Glass breakage sensor (GBS)
3 Combination GBS + MC. First GBS, then MC. End-of-line resistor R
Internal end-of-line resistor R
For a nominal value
Otherwise the EOLresistor has to be connected externally.
A detector group that is not being used requires no end-of-line resistor if it is not assigned to a
function in the control panel.
Cover
contact
MC GBS
R
EOL
1 2
(MC), connection in Z-wiring.
, connection
R = 12k1 the internal EOL resistor can be used.
EOL
DG1
R
12k1
A
int.
0 V
DG2
R
12k1
A
int.
0 V
GBS + MC
3
depends on the programming.
EOL
in Z-wiring.
int. = 12k1:
EOL
Detector group 1
Detector group 2
R
EOL
at end of line.
EOL