Setting The Number Of Cycles; Pause After An Unsuccessful Cycle - HumanTechnik flashtel comfort II LB f Bedienungsanleitung

Setting the number of cycles

A cycle is defined as dialing all the programmed SOS phone numbers in one consecutive
sequence. By setting the number of cycles you will define how frequently the phone num-
bers are to be dialed.
1. Press the P button and then the
2. Enter the four-digit device PIN "XXXX" (the telephone's default PIN code is "0000").
3. Enter the code "350".
4. Enter the number of cycles using the number keys 1-8.
If you press 9, the telephone will keep transmitting the SOS call until it is answered.
5. Press the P button to save the changes.
6. Re-enter a code or press the P button to exit the Settings menu.
Note:
The telephone's default is 3 cycles.

Pause after an unsuccessful cycle

You can specify the pause (1-9 minutes) between the end of an unsuccessful cycle and the
start of a new cycle.
1. Press the P button and then the
2. Enter the four-digit device PIN "XXXX" (the telephone's default PIN code is "0000").
3. Enter the code "351".
4. Enter the duration of the pause using the number keys 1-9.
5. Press the P button to save the changes.
6. Re-enter a code or press the P button to exit the Settings menu.
Note:
The SOS LED flashes during the pause between cycles and is illuminated constantly during
cycles.
50 English
button.
button.