Drive Cover - Bosch MUM 2 Serie Gebrauchsanleitung

en Basic operation
Before changing tools or cleaning
▶
the appliance, switch off and dis-
connect it from the mains.
Only use the tools when the bowl
▶
is inserted, the lid is fitted and the
drive covers are in place.
Never open the swivel arm during
▶
processing.
Requirements
¡ The bowl has been inserted.
¡ The required tool is inserted.
Add the ingredients to the bowl.
1.
Press the release button and push
2.
the swivel arm down until it en-
gages.
Insert the mains plug.
3.
Set the rotary switch to the re-
4.
quired speed.
→ Fig.
13
Process the ingredients until you
5.
achieve the required result.
Set the rotary switch to
6.
→ Fig.
14
Wait until the appliance stops.
Unplug the mains plug.
7.
Tips
¡ You can change the speed at any
time during processing or interrupt
processing.
¡ Clean all parts immediately after
use so that residues do not dry on.
Adding more ingredients
To add ingredients during pro-
1.
cessing, use the filling shaft in the
lid.
→ Fig.
15
To add large quantities, set the
2.
rotary switch to
Wait until the appliance stops.
Remove the bowl lid.
3.
→ "Removing bowl lid", Page 35
Add the ingredients to the bowl.
4.
Attach the bowl lid.
5.
→ "Attaching bowl lid", Page 35
36
⁠ .
⁠ .
Process the ingredients until you
6.
achieve the required result.
Using instantaneous switching
Set the rotary switch to
1.
hold.
→ Fig.
16
a The ingredients are processed at
maximum speed.
Release the rotary switch.
2.
→ Fig.
17
a The rotary switch springs to
a Processing stops and the drives
move to the parked position.
Tip
Instantaneous switching is especially
suitable when using the following
accessories:
¡ Blender attachment
¡ Multi-chopper set
¡ Multi-blender attachment

Drive cover

Remove the protective cover to use
accessories on drive 2 or 3.
Removing drive cover
Lift the protective cover of drive 2
1.
by the side lug and remove.
→ Fig.
18
Pull up the protective cover for
2.
drive 3 and remove.
→ Fig.
19
Fitting drive cover
Position the protective cover for
1.
the drive 2 and press in place
firmly.
→ Fig.
20
Position the protective cover for
2.
the drive 3 and press in place
firmly.
→ Fig.
21
Markings
up.
and
and must match
⁠ .