Ryobi REM 1033 Gebrauchsanleitung Seite 11

BASIC SAFETY PRECAUTIONS
E40. WARNING:
DO NOT USE AN EXTENSION CABLE
WHICH SHOWS SIGNS OF DAMAGE. FIT
A NEW CABLE COMPLETE
DO NOT MAKE ANY PERMANENT OR
TEMPO- RARY REPAIRS.
E 41. Always supply the machine through a
residual current circuit breaker (RCCB) with
a cutout current not above 30 mA. Use an
H05 RN-F or H05 VV-F or heavier power
cable, with a minimum cross section of
2x1.5 mm and maximum length 20 m.
2
The power mains connection plug must be
covered in rubber and protected against
sprays (IPX4). WARNING! The use of the
RCCB does not exempt the operator from
taking all the safety precautions indicated
in this manual.
note ___________________________________
___________________________________
___________________________________
__________________________________
__________________________________
_________________________________
__________________________________
_____________________________________________
___________________________________
___________________________________
__________________________________
__________________________________
_________________________________
__________________________________
__________________________________
__________________________________
_________________________________
__________________________________
__________________________________
__________________________________
_________________________________
__________________________________
__________________________________
__________________________________
_________________________________
__________________________________
__________________________________
__________________________________
_________________________________
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
_________________________________
__________________________________
GB
11