Installing The Power Supply - Fujitsu D2618 Kurzanleitung

Mainboard D2618

Installing the Power Supply

There are three power connectors on this motherboard:
● 24-pin PWR1 power connector
● 8-pin PWR2 power connector
● 10-pin PWR3 power connector
D2618 is powered by a split plane PSU with six +12V-rails and 1000W continuous power. Four rails
are for the systemboard and two for peripherals (e.g. HHDs, graphics card).
The power supply has:
● one 24-pin molex-type connector for the baseboard (P1)
● one 8-pin molex-type connector for the processor power (P17)
● one 10-pin molex-type additional baseboard power connector (P18) – two yellow wires and two
black wires (only for use with this workstation)
● four 6-pin connectors for graphic adapters (P12, P13, P15, P16)
● two 8-pin connectors for graphic adapters (P11, P14)
● several HDD-, floppy- and SATA power connectors
Incorrect replacement of the lithium battery may lead to a risk of explosion!
!
You must unplug the power supply before plugging in the power cables to motherboard
connectors.
Fujitsu Technology Solutions
English - 33
33