Maintenance; Service; Daily Maintenance - Husqvarna WS 440 HF Bedienungsanweisung

Service

IMPORTANT! All types of repairs may only be carried out by
authorised repairmen. This is so that the operators are not
exposed to great risks.
After 100 hours of operation, the message "Time for
servicing" is displayed. The entire equipment shall then be
taken to an authorized Husqvarna dealer for servicing.

Maintenance

IMPORTANT! Inspection and/or maintenance should be
carried out with the motor switched off and the plug
disconnected.
Oil change cutting arm
There is an oil plug for draining the oil located on the cutting
arm. This plug should be cleaned when changing the oil. The
new oil is filled through the hole where the oil plug sits.
The cutting arm contains 3 dl of Husqvarna Oil 150, a
transmission oil of the type EP 150. The oil should be
replaced for the first time in connection with the first service.
A 3 dl bottle of oil is supplied when the machine is new.
IMPORTANT! Used engine oil and transmission oil is
hazardous to health and must not be disposed of in the
ground or out of doors.
14 –
English
MAINTENANCE
Lubrication of feeder gears
IMPORTANT! If the gears are not lubricated regularly, their
lifespan will shorten considerably.
There are two grease nipples on every saw unit. Through
these the gears for the feeding engines can be lubricated.
Lubricate daily or at least every 30 hours of operation. Use
VEIDEC POWER LUBE or corresponding grease.
Grease the blade spindle
In order for the blade spindle to be fitted as easily as possible,
it may be necessary to grease the hexagonal blade spindle.
At the same time check that the hexagon is not damaged.

Daily maintenance

1 Check that all couplings, connections and cables are
intact and free from dirt.
2 Clean the outside of the machine. Do not use a high
pressure washer to clean the saw.
3 Check that the blade and th blade guard is not damaged
or cracked. Replace the blade or the blade guard if it is
exposed to impact or is cracked.