Using The Appliance - Washing & Drying - AEG LB3470WT Benutzerhandbuch

22 www.aeg.com
USING THE APPLIANCE - WASHING & DRYING
NON-STOP PROGRAMME -
WASHING & AUTOMATIC
DRYING
CAUTION!
Do not put a plastic device/ball
for the detergent into the drum.
• Press button
ance.
• Load the laundry.
• Measure out the detergent and fabric
conditioner.
• Turn the programme dial to the wash-
ing programme. The display shows the
wash symbols.
CAUTION!
Do not set a spin speed lower
than the automatic speed of the
set programme.
• Set the available options.
• Press the button
appears under one of the dryness level
symbol.
The time value on the display is the du-
ration of the washing + drying cycles
calculated on a default load size.
• Press button
gramme.
The display shows the new time value
each minute.
1 to activate the appli-
until the black line
7
The iron dry level
comes on.
The cupboard dry lev-
el comes on.
The extra dry level
comes on.
The drying symbol
comes on.
4 to start the pro-
The set dryness level sym-
bol stays on.
The others level symbols go
off.
The door locked symbol
comes on.
The last minutes of the drying cy-
cle the appliance performs the an-
ti-crease and the cooling phases.
• When the programme is completed,
the appliance stops automatically.
• The acoustic signals operate.
•
When the symbol
can open the door.
• Remove the laundry from the appli-
ance. Make sure that the drum is emp-
ty.
• Close the water tap.
• Keep the door ajar, to prevent mildew
and odours.
NON-STOP PROGRAMME -
WASHING & TIMED DRYING
CAUTION!
Do not put a plastic device/ball
for the detergent into the drum.
• Press button
to activate the appli-
1
ance.
• Load the laundry.
• Measure out the detergent and the fab-
ric conditioner.
• Turn the programme dial to the wash-
ing programme. The display shows the
wash symbols.
Do not set a spin speed lower than
the automatic speed of the set pro-
gramme.
• Set the available options.
• Press the button
time value. The display shows a mini-
mum time value.
The drying symbol comes
on.
Set drying time value
• After some seconds the display shows
the total duration of the cycles.
Final time value (washing
+ drying + anti-crease +
cooling phases)
goes off, you
to set the drying
7