Unfolding The Handle; Filling The Engine With Oil - Toro Multicycler 20637 Bedienungsanleitung

Setup

1. Unfolding the Handle

Procedure
1. Unlock the handle locks, move the handle sections
into the operating position, and lock the handle locks
(Figure 3).
2. Unlock the upper handle locks and rotate the upper
handle upward and lock it into a position that is
comfortable to you (Figure 4).
1. Highest position
2. Middle position
Note: You can set the upper handle to 1 of 3 handle
positions. Line up the mark to one of the 3 marks on
the inner side of the upper handle locks (Figure 4).
Note: If a handle lever is loose, open the lever,
rotate it clockwise 1 or 2 turns to tighten it, then
close the lever (Figure 5).
Figure 3
Figure 4
3. Lowest position

2. Filling the Engine with Oil

Procedure
Your mower does not come with oil in the engine.
1. Remove the dipstick (Figure 6).
2. Slowly pour oil into the oil fill tube until the oil level
reaches the Full mark on the dipstick (Figure 6).
Do not overfill. (Max. fill: 0.59 l, type: SAE 30
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.)
3. Install the dipstick securely.
Important: Change the engine oil after the first
5 operating hours
Refer to Changing the Engine Oil.
5
Figure 5
Figure 6
; change it yearly thereafter.