Abicor Binzel MF1/2 Betriebsanleitung Seite 36

11 Dismounting
11 Dismounting
12 Disposal
12.1 Materials
EN - 18
Dismounting may only be carried out by qualified personnel. Please make sure
that the shutdown procedures are strictly observed before the dismounting
work begins. Ensure this also for the components integrated into the welding
system.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Close off the gas supply.
• Switch off the entire welding system.
• Pull the mains plug.
NOTE
• Observe the information given in section 8 Putting out of operation on
page EN-15.
1 Disconnect the cable assembly from the wire feeder.
2 Remove parts to be disconnected.
3 Dismount the MF1/2 master feeder from the fastener on the torch.
For disposal, the local regulations, laws, provisions, standards and guidelines
must be observed. For the product to be properly disposed of, it first must be
dismounted.
 See 11 Dismounting on page EN-18
This product consists for the most part of plastics, steel and non-ferrous metals.
Steel and non-ferrous metals can be molten in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are marked in
preparation for sorting and separation of the materials for later recycling.
MF1/2