Abicor Binzel MF1/2 Betriebsanleitung Seite 28

6 Putting into operation
1
1 Protection cap
2 Knurled screws for pressure roll
3 Eccentric bolt
4 Knurled screws for drive rollers
5 Feed rollers - drive rollers
Fig. 3 Mounting the feed rollers
6.1.1 Pressure rolls
EN - 10
2
11
6 Knurled screw
7 Wire guide between the rollers
8 Axle
9 Pressure rocker
1 Take protection cap (1) off moving it upward.
2 Rotate eccentric bolt (3) and take it out toward the top.
3 Unscrew knurled screw (6) and pull off pressure rocker (9).
4 Loosen the knurled screws (2) and take out the axle (8) pushing it
downward.
5 Remove drive gears (10).
6 Place feed rollers (11) on drive gears (10).
7 Insert drive gears (10) and axle (8) and secure with knurled screw (2).
8 Place pressure rocker (9) on bolt again and secure it with knurled
screw (6).
3
10 9
10 Drive gears
11 Feed rollers - pressure rolls
MF1/2
4 5
6
7
8
diameter
MF1 20 mm
diameter
MF2 30 mm