Troubleshooting; Disposal - MAXXMEE EMS-Set Bedienungsanleitung

EMS Set

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an elec-
trical device yourself!
A controller (2) does not work. / The
programme lamps (5) do not light
up.
No batteries or empty batteries have
been inserted in the controller.
► Insert / replace batteries.
The batteries are inserted incorrectly.
► Pay attention to the correct polarity
when inserting the batteries.
The programme lamps (5) light up,
but do not fl ash.
There is no contact between the skin and
silicon electrodes.
► Make sure that the pads fit correctly.
The controller (2) is not correctly attached
to the pad.
► Check whether the controller is cor-
rectly attached to the press studs.
The programme lights (5) are fl ash-
ing, but no pulses are being sent to
stimulate the muscles.
The pad is not placed on correctly.
► Keep changing the position of the
pad until the spot with the strongest
muscle contraction has been found.
The intensity level is set too low.
► Press the ON / + button (8) to increase
the intensity level.
The pads no longer stick.
The pads are not clean.
► Clean the used pads under running
water.
The silicon electrodes are too old.
► A replacement set can be ordered via
our customer service department.

DISPOSAL

Dispose of the packaging mate-
rial in an environmentally friendly
manner so that it can be recycled.
Batteries should be removed from
the controllers before disposing of
the device and disposed of sepa-
rately from the device at suitable
collection points.
This device is governed by the
European Directive 2012/19/EU
on waste electrical and electronic
equipment (WEEE). Do not dispose
of this device as normal domestic
waste, but rather in an environ-
mentally friendly manner via an
offi cially approved waste disposal
company.
EN
15