Klarstein Hot Spot Crystal Reflect Smart Handbuch Seite 17

Wall mounting
1. Drill two holes (diameter < 8 mm) on each side of the wall and insert a plastic
dowel into each hole Then fix the brackets with the 4 x 35 mm screws (the distance
between the holes should be as shown below).
Bracket 1
2. Insert the top row of retaining screws into the bracket and fix it with the nuts and
washers (see figure 1).
3. The spacers are screwed onto the upper row of retaining screws at the bottom and
can be adjusted accordingly (see figure 2).
1
Bracket 2
2
EN
17