Protecting The Environment - DeWalt DW341 Übersetzung Der Originalanweisung

• Use high speeds for sawing soft materials such as wood. Use
low speeds for sawing metal.

WARNING: After using the tool for an extended period
on low speed settings, run it for approx. 3 minutes on
maximum no‑load speed.
Sawing in Wood (Fig. J)
• If necessary, draw a cutting line.
• Switch the tool on.
• Hold the tool against the workpiece and follow the line.
• For sawing parallel to the edge of your workpiece, install the
parallel fence and guide your jigsaw along the workpiece a
shown in Figure J.
Sawing in Wood Using a Pilot Hole (Fig. K)
• If necessary, draw a cutting line.
• Drill a hole (ø min. 12 mm) and introduce the saw blade.
• Switch the tool on.
• Follow the line.
• For cutting perfectly round shapes, install the trammel bar and
set it to the required radius.
Sawing Up to a Projecting Edge (Fig. L)
• Using a conventional blade, cut up to the projected edge.
• Finish off the cut using a flush cutting blade.
Sawing in Metal
• Mount an appropriate saw blade.
• Proceed as described above.

WARNING: Use a cooling lubricant (cutting oil) to prevent
overheating of the saw blade or the workpiece
Dust Extraction (Fig. F)
• When the tool is used indoor for extended periods of time,
use a suitable dust extractor designed in compliance with
the applicable Directives regarding dust emission.
MAINTENANCE
Your power tool has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. An accidental
start‑up can cause injury.
C
Lubrication
Your power tool requires no additional lubrication.
D
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non‑metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. Products marked with this
w
symbol must not be disposed of with normal
household waste.
Products contain materials that can be recovered
or recycled reducing the demand for raw materials. Please
recycle electrical products according to local provisions. Further
information is available at www.2helpU.com.
EngLIsh
WALT recommended
e
23