IBP BP 603 Gebrauchsanweisung Seite 43

making a blood pressure measurement 9
9.1 attaching the wrist cuff
a) Before using, insert the connector of the air
hose into the air hose connection of the unit
(a). The blood pressure monitor is used as a
desktop/tabletop unit.
Insert the end of the sleeve through the metal
b)
strap so that the sleeve acquires a tunnel
shape (b).
c)
Put your left arm through the cuff loop (c).
Position the orange sleeve marking at the
middle of the arm, in line with your middle
finger (d). Tighten the cuff by pulling the end
of the cuff.
d)
Turn your left palm upward and place the
edge of the arm cuff at approximately 2 to 3
cm above the inner side of the elbow joint (e).
e) If the cuff is not pulled tight you get wrong
measure values.
a
e
2-3 cm
c
fig. 4
b
d
orange sleeve
marking
13