IKEA MÖJLIG Domino Bedienungsanleitung Seite 16

ENGLISH
Problem
Acoustic signal sounds, ap-
pliance deactivates.
The residual heat indicator is
not displaying anything.
There is no signal when you
touch panel symbols.
symbol plus a number
appears on the timer dis-
play.
lights up on the timer
display.
If there is an error, first try to find a solution
to the problem yourself. If you cannot find a
solution to the problem yourself, contact
your IKEA store call centre. You can find a
full list of IKEA appointed contacts at the
end of this manual.
Possible cause
One or more symbols have
been covered for longer
than 10 seconds.
The cooking zone was only
on for a short time and is
therefore not hot.
The signals are deactivated. Activate the signals. Refer to
Electronic component error.
The second phase of the
power supply is missing.
Remedy
Uncover symbols.
If the cooking zone is sup-
posed to be hot, call the Af-
ter Sales Service.
OffSound Control.
Disconnect the appliance
from the electrical supply for
a few minutes. Remove the
fuse, wait one minute, and
insert the fuse again. If the
problem continues, ensure a
correct installation by calling
an authorised installer.
Check if the appliance is
connected correctly to the
electrical supply. Remove
the fuse, wait for one minute,
and insert the fuse again. If
the problem continues, en-
sure a correct installation by
calling an authorised instal-
ler.
If you operated the appliance
wrongly, or the installation was
not carried out by a registered
engineer, the visit from the After
Sales Service technician or
dealer may not take place free
of charge, even during the
warranty period.
16