ESX Quantum QS-TWO Benutzerhandbuch Seite 19

AUTO
TURN-ON
OFF VOX DC
Q S–TWO
Connect stereo RCA output (L/R or SUB OUT)
of the head unit with INPUT (L/R) of the amplifier
INTERCONNECTION
• Connect the RCA outputs of the head unit with the RCA jacks INPUT (L /R) of the amplifier with appropriate high-value RCA cables
by using the included wire harness. If a separate SUB OUT from your head unit is available, use this as line output.
• Connect the subwoofer with the SPEAKER OUTPUTS by using the included wire harness.
• Always ensure that the total impedance load is not lower than 4 ohms.
Too low impedance cause high temperature and will shut down the amplifier operation.
• Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
CROSSOVER SETTINGS & BASS BOOST CONTROLLER
• The X-OVER switch must be in position LP. The cut-off frequency is fixed at 80 Hz.
LEVEL CONTROLLER
• Turn the LEVEL INPUT controller of the amplifier to the MIN position.
• Turn the volume controller of the head unit to 80 - 90% of its full setting.
• Turn the LEVEL INPUT controller clockwise until you hear some distortion.
• Then turn back the LEVEL INPUT controller slightly until you hear a cleaner sound.
FUNCTIONAL INSTRUCTIONS
INTERCONNECTION EXAMPLE
1-channel-mode: 1 x Mono Subwoofer bridged
LP
LEVEL
L R L R
X-OVER
INPUT
LP HP FULL
INPUT OUTPUT
MIN MAX
Subwoofer
4 – 8 Ohms
POWER
SPEAKER
INPUT
OUTPUT POWER
PROTECT
L R
L R
+12V REM
BRIDGED
IN/OUT
GND
19