ESX Quantum QS-TWO Benutzerhandbuch Seite 17

Connect the INPUT RCA jacks of the included wire harness with the head unit by using appropriate audio signal cables.
9
If your head unit does not have RCA preamp outputs, you can use the amplifier's high level inputs as signal input. Simply connect
the loudspeaker cables of the head unit to the enclosed wire harness as follows:
The OUTPUT RCA jacks of both wire harnesses provide a linear full-range audio signal for driving additional amplifiers.
10 To connect the speaker cables, use the enclosed wire harness and plug it into the SPEAKER OUTPUT connector.
If the POWER/PROTECT is blue, the amplifier is ready for operation. If the POWER/PROTECT is red, there is a malfunction.
11
Refer in this case to the section TROUBLE SHOOTING.
FUNCTIONAL INSTRUCTIONS
OPERATING ELEMENTS
10 11
SPEAKER
OUTPUT
POWER
PROTECT
L R
L R
BRIDGED
POWER
INPUT
+12V REM GND
IN/OUT
SPEAKER OUTPUT -
SPEAKER OUTPUT -
INPUT L+
INPUT L-
INPUT R+
INPUT R-
OUTPUT L
OUTPUT R
INPUT L
INPUT R
OUTPUT L
OUTPUT R
INPUT L
INPUT R
OUTPUT L
SPEAKER OUTPUT +
SPEAKER OUTPUT +
OUTPUT R
SPEAKER OUTPUT -
SPEAKER OUTPUT -
L +
L-
INPUT L+
R +
INPUT L-
R-
INPUT R+
INPUT R-
INPUT L
OUTPUT L
INPUT R
OUTPUT R
OUTPUT L
INPUT L+
OUTPUT R
INPUT L-
INPUT R+
INPUT R-
OUTPUT L
OUTPUT R
L +
L-
R +
R-
INPUT L+
INPUT L-
INPUT R+
INPUT R-
OUTPUT L
OUTPUT R
17