Operation - cecotec Cumbia POWER ESPRESSO 2.0 Bedienungsanleitung

Insert the stainless-steel filter into the portafilter without ground coffee. Then, insert the
portafilter into the appliance, matching the shape of the filter holder and the shape of the
water outlet. Turn it counter clockwise until the handle is aligned with the "lock" mark on the
appliance.
Place a jug on the removable grid. Make sure the steam extraction knob is off.
Plug the device into a power supply. The plug must be accessible so that, in case of an
emergency, it can be easily unplugged.
Press the coffee button ready and the indicator light will start blinking. Wait until the indicator
light stops blinking.
Press the coffee button. The machine will pump water into the jug; press the button again when
the jug is full to stop. The light indicator will blink again until the product stops preheating.
Repeat this process twice.
Note: you may hear a noise when the appliance pumps water for the first time. It is completely
normal, the appliance is releasing air in its interior. After about 20 seconds, the noise will
disappear.

3. OPERATION

Preheating
To prepare a cup of good hot espresso coffee, it is recommended to preheat the appliance
before brewing coffee, including the filter holder, filter, and cup, so that the flavour of the
coffee is not altered by any cold part.
Remove the detachable tank, open the tank cover, and fill it with water. The water level should
not exceed the "MAX" mark in the tank. Install the tank back in the appliance.
Insert the stainless-steel filter into the portafilter. Then, insert the portafilter into the
appliance, matching the shape of the filter holder and the shape of the water outlet. Turn it
counter clockwise until the handle is aligned with the "lock" mark on the appliance.
Place an espresso cup on the removable grid.
Connect the coffee machine to a power supply. Make sure the steam extraction knob is off.
Press the coffee button ready and the indicator light will start blinking. Wait until the indicator
light stops blinking.
Press the coffee button. The machine will pump water into the cup, heating all parts that are
going to be in contact with coffee. Press the button again when the cup is full to stop brewing.
The light indicator will blink again until the product stops preheating.
How to prepare an espresso
After preheating, remove the portafilter from the main body by turning it clockwise. Use a dry
cloth to dry it. Fill the filter with ground coffee using the measuring spoon and press it tightly
with the other end of the spoon.
Then, insert the portafilter into the appliance, matching the shape of the filter holder and the
01503_Cumbia Power Expresso 20 _Manual_YV_02020218.indd 39 01503_Cumbia Power Expresso 20 _Manual_YV_02020218.indd 39
ENGLISH
39
POWER ESPRESSO 20
18/2/20 15:56 18/2/20 15:56