Connection / Electrical safety
Never work alone in dangerous conditions.
Always ensure that plugs, socket outlets and input cables
are in good working order.
Connect the UPS system only to an earthed socket outlet.
Ensure maximum current draw and that the building wiring
is adequately fused.
The building wiring socket outlet (with earthing contact)
must be easily accessible and close to the UPS system.
Only use VDE-tested and CE-marked connecting cables.
As specified by the EMC Directive, the output cable con-
nected to the UPS must not exceed a length of 10m.
Do not connect household appliances such as hair dryers
to UPS output sockets.
Do not connect any appliances to UPS output sockets
which will overload the UPS (e.g. laser printers).
Lay cables in such a way that no one can step on or trip
over them.
Operation
Do not disconnect the mains cable from the UPS system or
the building wiring socket outlet (with earthing contact) dur-
ing operation, since this would cancel the protective earth-
ing of the UPS system and of all connected loads.
The UPS system features its own, internal current source
(batteries). The UPS output sockets may be electrically live
even if the UPS system is not connected to the socket out-
let / the building wiring supply.
In order to fully disconnect the UPS system, first press and
hold down the OFF button for at least 2 seconds, then dis-
connect the mains lead.
Ensure that no fluids or other foreign objects can enter the
UPS system.
Seite 51 von 128