Cleaning And Care - Klarstein Pizzaiolo Pro Bedienungsanleitung

CLEANING AND CARE

WARNING: Danger of burns
All cleaning and maintenance should be carried out when the barbecue
is cool and with the fuel supply turned OFF at the gas cylinder.
Your gas grill will look better and last longer if you keep it clean.
You should check the burner periodically for any sort of blockage. To do this, remove
and inspect it. If any of the holes are clogged, gently tap the burner onto a hard surface
to remove residue. Use a wire brush to unclog the holes. Once this is done, lightly coat
the burner with oil to help protect the burner.
Grease can build up on the frame itself. Most of it can be cleaned off with hot water.
Use a non-caustic cleanser for more stubborn stains.
You should empty the fat tray frequently . Never touch the drip tray until the gas grill
and fat have cooled down completely.
Cooking grid
CAUTION: All cleaning and maintenance should be carried out when the barbecue is
cool and with the fuel supply turned OFF at the gas cylinder.
To reduce chance of "FLASH-BACK" the procedure below should be followed at least
once a month in late summer or early fall when spiders are most active or when your
grill has not been used for a period of time.
1. Turn all burners' valve to the full OFF position.
2. Turn the LPG cylinder valve(clockwise) to the full OFF position.
3. Detach the regulator assembly from the LPG cylinder by turning the quick Coupling
Nut clockwise.
4. Remove the grid, cooking stone, grill rack from the appliance.
5. Remove the burner from the bottom of the grill bowl by pulling the burner clip. Use
a screwdriver or needle nose pliers.
6. Carefully lift the burner up and away from the gas valve orifice.
7. Refer to figure below and perform one of these three cleaning methods.
Bend a stiff wire, (a lightweight coat hanger works well) into a small hook as shown
below. Run the hook through the burner tube and inside the burner several times to
remove any debris.
Use a bottle brush with a flexible handle. Run the brush through the burner tube and
inside the burner several times, removing any debris.
Use an air hose to force air through each burner tube. The forced air should pass debris
or obstructions through the burner and out the ports.
EN
37