Declaration Of Conformity; Dust/Chip Extraction - Bosch PST 650 L Bedienungsanleitung

OBJ_BUCH-2 609 000 687-001.book Page 4 Tuesday, February 1, 2005 3:50 PM
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents:
EN 60745, EN 60825-1 according to the provisions of
the directives 89/336/EEC, 98/37/EC.
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Geschäftsbereich Elektrowerkzeuge
Assembly

Dust/Chip Extraction

Take safety measures when dusts can be pro-
duced during working that are detrimental to
one's health, inflammable or explosive. Example:
Some dusts are regarded as carcinogenic. Use suita-
ble dust/chip extraction and wear a dust respirator.
Keep your workplace clean. Blends of materials are
particularly dangerous. Dust from light alloys can burn
or explode.
Dust Cover
Mount the dust cover 15 before connecting the
machine to the dust extraction.
Place the dust cover from the front into the guide so
that it latches.
For work without dust extraction, the dust cover 15 can
be removed. To remove the dust cover 15, grasp it by
the side and pull it off toward the front.
Connecting the Dust Extraction
Place a vacuum hose 3 (accessory) onto the vacuum
connection 4. Connect the vacuum hose 3 with a vac-
uum cleaner (accessory). An overview for the connec-
tion of various vacuum cleaners can be found at the end
of these instructions.
The vacuum cleaner must be suitable for the material
being worked.
When vacuuming dry dust that is especially detrimental
to health or carcinogenic, use a special vacuum
cleaner.
2 609 000 687 • 1.2.05
Downloaded from www.Manualslib.com

Declaration of Conformity

Dr. Eckerhard Strötgen
Head of Product
Certification
manuals search engine
Replacing/Inserting the Saw Blade
Before any work on the machine itself, pull the
mains plug.
When mounting the saw blade, wear protective
gloves. Danger of injury when touching the saw blade.
Selecting a Saw Blade
An overview of recommended saw blades can be found
at the end of these instructions. Use only T-shank saw
blades. The saw blade should not be longer than
required for the intended cut.
Use a thin saw blade for narrow curve cuts.
Inserting the Saw Blade (see figure B
If required, remove the dust cover 15 (see Dust Cover).
Insert the saw blade 11 (teeth in cutting direction) into
the stroke rod 14 until it latches. The SDS lever 10
automatically snaps to the rear and the saw blade is
locked. Do not manually press the lever 10 toward the
rear, otherwise you could damage the machine.
While inserting the saw blade, pay attention that the
back of the saw blade is positioned in the groove of the
guide roller 9.
Check the tight seating of the saw blade. A loose
saw blade can fall out and lead to injuries.
Ejecting the Saw Blade (see figure B
When ejecting the saw blade, hold the machine
in such a manner that no persons or animals can
be injured by the ejected saw blade.
Turn the SDS lever 10 toward the front in the direction
of the arrow. The saw blade is released and ejected.
Splinter Guard (see figure C)
The splinter guard 19 (accessory) can prevent fraying
of the surface while sawing wood. The splinter guard
can only be used for certain saw blade types and only
for cutting angles of 0°. When sawing with the splinter
guard, the base plate 6 must not be moved back for
cuts that are close to the edge.
Press the splinter guard 19 from the bottom into the
base plate 6.
English–4
)
)