First Aid; Safety Notices - AEG SP16 Bedienungsanleitung

10
Technical Specifications
the jumper leads meet the requirements of DiN 72553 and are suitable for
wiring system voltages from of 12 V and 24 V.
the leads consist of insulated, copper-clad aluminium wires with fully insulated
terminal clamps.
Typ Item No. Cross-section* /
Length
sP 16 97203 16 mm² /
2 x 3 m
sP 25 97204 25 mm² /
2 x 3,5 m
sP 35 97205 35 mm² /
2 x 4,5 m
* the electric conductance corresponds to a copper lead of this cross-section.

firSt aiD

in the event of contact with battery acid immediately wash or flush the affected
areas under running water. Seek immediate medical attention for chemical
burns of the eye or mucous membranes.
For engine displacement
up to
Petrol Diesel
2500 cm³ -
5500 cm³ 3000 cm³
7000 cm³ 4000 cm³

SafEtY NOtiCES

Warning!
fatal or dangerous to children!
Children are unable to assess the risks associated with this product!
Choking and strangulation hazard!
Do not allow children to play with the packaging materials and this product.
Warning!
risk of injury, fire and damage by short circuit!
■
improper handling of jumper leads may result in severe injuries and damage.
Danger! Damaged leads may cause fatal electric shock. Discontinue use if
■
leads are damaged. repairs must be performed by a qualified professional.
risk of explosion and fire! keep sources of ignition (e.g. lit cigarettes)
■
away from battery.
■ risk of chemical burns! risk of injury to the eye. Wear protective eyewear
and do not lean over the battery. the electrolyte inside the drained starter
battery remains liquid even at low temperatures.
■ risk of explosion! the working battery must have the same voltage (V)
and about the same capacitance (ah) as the drained battery
(see specification on the battery).
■ risk of explosion! Never use the jumper leads in
explosion-prone surroundings.
■ risk of explosion! thaw frozen batteries before starting.
■ risk of short circuit! Never allow the vehicles to touch.
■ risk of short circuit! Never allow the contacts of the lead connected
to the battery's positive terminal to come into contact with electrically
conductive vehicle parts.
■ fire hazard! the vehicle's engine displacement must be within the approved
range of the jumper leads.
■ risk of injury! Do not modify or manipulate the product as this will increase
the risk of injury.
11
Gb