Operation; Wheel Assembly - ATH-Heinl W142 Bedienungsanleitung

1.3

Operation

1.3.1 Self test
After it is switched on, the device carries out a self
test and then automatically switches to "dynamic"
mode

1.3.2 Wheel assembly

Select the correct cone to centre the wheel on the balancing flange.
As shown below, there are 2 easy ways to mount the wheel.
a. The first way of mounting a wheel is
shown opposite.
Using this method, the wheel rim is stretched
onto the balancing shaft from the exterior.
If you are using the largest cone, the
extension piece for the clamping cone must
also be used.
This method increases the risk of
clamping errors and is therefore only
recommended for use with steel rims.
b. When using the second method, first
position the tension springs on the
balancing shaft and then a suitable
cone. The wheel rim can be stretched
onto the balancing shaft using a
pressure hood.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
Manufacturer ATH-Heinl GmbH & CO.KG
- 7 -