Troubleshooting Tips; Troubleshooting & Tips; Before Calling For Service - Scandomestic SFO 100 Bedienungsanleitung

TROUBLESHOOTING TIPS

Before calling for service

Reviewing the charts on the following pages may save you from calling for service.
Problem
Dishwasher doesn't
start
Water not pumped
form dishwasher
Suds in the tub
Possible Causes
Fuse blown, or the
circuit break tripped.
Power supply is not
turned on.
Error code:E1;
Water pressure is low
Door of dishwasher
not properly closed.
Twisted or trapped
drain hose.
Filter clogged.
Kitchen sink clogged.
Wrong detergent.
31
What To Do
Replace fuse or reset circuit breaker.
Remove any other appliances sharing
the same circuit with the dishwasher.
Make sure the dishwasher is turned
on and the door is closed securely.
Make sure the power cord is
properly plugged into the wall socket.
Check that the water supply is
connected properly andthe water
is turned on.
Make sure to close the door
properly and latch it.
Check the drain hose.
Check coarse the filter.
Check the kitchen sink to make sure
it is draining well.If the problem is
the kitchen sink that is not draining ,
you may need a plumber rather than
a serviceman for dishwashers.
Use only the dedicated dishwasher
detergent to avoid suds. If suds exist
in the washer. Open the door for
20-30 minutes to allow the foam to
evaporate. If the foam still exists in
the liner. Add 1.5L of water to the
liner, close the dishwasher door and
run a forced drain to drain it with the
water. Repeat above operation until
the foam is cleared.