Turning On The Appliance; Change The Programme - Scandomestic SFO 100 Bedienungsanleitung

NOTE
EN 50242: This program is the test cycle. The information for comparability
test in accordance with EN 50242, are as follows:
The power consumption of off-mode is 0.49W,
left-on mode is 0.49W

Turning on the appliance

Starting a wash cycle...
Draw out the basket(see the section entitled "Loading the Dishwasher").
Pour in the detergent (see the section"Fill the detergent").
Insert the plug into the socket. The power supply is 220-240VAC 50 HZ, the
specification of the socket is 10 A 250 VAC.
Press the power button to turn on the appliance,
Connect the inlet hose to the tap, make sure that the water supply is turned on
to full pressure, or add water the the tank manually.
select a suitable program according to the "Wash cycle table";
If a program is selected, the response light will light. Then press the Start/ Pause
button, the dishwasher begins to start.
NOTE
When you press the Start/Reset button to pause during washing,the
dishwasher will mooing every minute unless you press the Start/Reset
button to start.

Change the programme

Premise: You can modify the washing program, If the dishwasher just worked for
a short time. Otherwise, the detergent may have already been released, and the
appliance may have already drained the wash water in this case, the cycle
must be restarted.
21