Using Your Dishwasher; Loading The Salt Into The Softener - Scandomestic SFO 100 Bedienungsanleitung

USING YOUR DISHWASHER

NOTE
If your model have no water softener, you may skip this section.

Loading the salt into the softener

Always use salt intended for use with dishwasher.The salt container is located
beneath the basket and should be filled as follows:
WANING
Only use salt specifically designed for dishwashers use!
Every other type of salt not specifically designed for dishwasher use,
especially table salt, will damage the water softener. In case of
damages caused by the use of unsuitable salt the manufacturer does
not give any warranty nor is liable for any damages caused.
Only fill with salt before running a cycle.
This will prevent any grains of salt or salty water, which may have
been spilled, remaining on the bottom of the machine for any period
of time, which may cause corrosion.
A. Remove the basket and then unscrew and remove the cap from the salt container.
B. Before first wash, add 1lt. of water in the salt container of your machine.
C. Place the end of the funnel (supplied) into the hole and introduce about , 0.13kg
of salt. It is normal for a small amount of water to come out of the salt container.
D. After filling the container, screw the cap tightly back clockwise.
12