Product Overview; Using Your Dishwasher; Loading The Salt Into The Softener - Scandomestic SFO 2203 W Bedienungsanleitung

your household waste disposal service. DISPOSAL: Do not dis-
pose this product as unsorted municipal waste. Collection of
such waste separately for special treatment is necessary.

PRODUCT OVERVIEW

IMPORTANT:
To get the best performance from your dishwasher, read all op-
erating instructions before using it for the first time.
A Salt container
B Dispenser
C Spray arm
D Filter assembly
Cutlery rack Cup rack
NOTE:
Pictures are only for reference, different models may be differ-
ent. Please prevail in kind.

USING YOUR DISHWASHER

Before using your dishwasher :
1. Set the water softener

2. Loading the Salt Into the Softener

3. Loading the basket
4. Fill the dispenser
Please check the section 1 "Water
Softener" of PART 2: Special Ver-
sion,
If you need to set the water softener
.
Loading The Salt Into The Softener
NOTE:
If your model does not have any water softener, you may skip
this section. Always use salt intended for dishwasher use.
Basket
The salt container is located beneath the lower basket and
should be filled as explained in the following:
WARNING
Only use salt specifically designed for dishwashers use!
Every other type of salt not specifically designed for dishwasher
use, especially table salt, will damage the water softener. In case
of damages caused by the use of unsuitable salt the manufactur-
er does not give any warranty nor is liable for any damages
caused.
Only fill with salt before running a cycle.
This will prevent any grains of salt or salty water, which may
have been spilled, remaining on the bottom of the machine for
any period of time, which may cause corrosion.
Please follow the steps below for adding dishwasher salt:
1. Remove the basket and unscrew the reservoir cap.
2. Place the end of the funnel (supplied) into the hole and pour
in about 1kg of dishwasher salt.
3. Before first wash, fill the salt container to its maximum limit
with water, It is normal for a small amount of water to come
out of the salt container.
4. After filling the container, screw back the cap tightly.
5. The salt warning light will stop being after the salt container
has been filled with salt.
6. Immediately after filling the salt into the salt container, a
washing program should be started (We suggest to use a
short program). Otherwise the filter system, pump or other
important parts of the machine may be damaged by salty
water. This is out of warranty.
NOTE:
The salt container must only be refilled when the salt warning
light in the control panel comes on. Depending on how well the
salt dissolves, the salt warning light may still be on even though
the salt container is filled.
If there is no salt warning light in the control panel (for some
Models), you can estimate when to fill the salt into the softener
by the cycles that the dishwasher has run.
If salt has spilled, run a soak or quick program to remove it.