4.3
Panel Flush Mounting or Cabinet Flush Mounting (7XT7100-0EA00)
Pull off the 2 covering caps on the front cover upward or downward as appropriate (see
²
Push the device, depending on the application, into the cut-out in the panel or in the control cabinet.
²
NOTE
i
i
Pay attention to the dimensions and notes in chapter
Fix the device to the panel or in the control cabinet with 4 screws.
²
[le_view_front-device_7XT71, 1, --_--]
Figure 4-3
(1)
M4 screws
Push the 2 covering caps back into the front cover (see
²
Wire the device according to chapter
²
In this type of assembly, the junction block is accessible from the back.
SIPROTEC 4/5, Injection unit 7XT71, Manual
C53000-B1174-C128-8, Edition 05.2020
Mounting the Device in the Panel
4.4
4.3 Panel Flush Mounting or Cabinet Flush Mounting (7XT7100-0EA00)
3.1 Dimensions of the Injection Units
Figure
4-1).
Connection.
Assembly and Connection
Figure
4-1).
7XT7100!
27