Mains Connection - powermatic PM1500 Gebrauchsanleitung

The back adjustment screws (F, Fig 13) allow a precise adjustment.
Info Note:
The back adjustment screws (F) also adjust the fence locking
positions.
- to take fence off (A, Fig 14)
- to slide fence along the guide rail (B)
- to lock fence in place (C)
To tilt the table, loosen the lock handle (A, Fig 14) and rotate the
knob (B).
The 90° table stop must be adjusted, so that the table is square to
the sawblade (Fig 15).
Place a square against the saw blade to inspect.
Downloaded from www.Manualslib.com
Fig 13
Fig 14
Fig 14
manuals search engine
Fig 15
Loosen nut (D, Fig 16) to adjust the stop bolt (C).
Fig 16
Make a final inspection on the fence setup.
If the fence is not exactly parallel to the saw blade, use the nylon
screws (C, Fig 17) to adjust.
Fig 17

5.3 Mains connection

Mains connection and any extension cords and plugs used must
comply with the information on the machine licence plate.
The mains connection must have a 16A surge-proof fuse.
Only use extension cords marked H07RN-F, with wires 1,5mm
more.
Power cords and plugs must be free from defects.
Connections and repairs to the electrical equipment may only be
carried out by qualified electricians.
or
2